A Tac-5 Paintball gun is a sophisticated weapon, although safer than a real gun, as it only shoots balls of paint. The numerous internal components require constant maintenance that only can be done by disassembling the Tac-5 before cleaning it. Assembling a Tac-5 paintball gun so it can be used again requires a few tools but no special skill. The reassembly can be completed in less than an hour.
Instructions
1. Put a bath towel on a table.
2. Place the bottom shell of the Tac-5 on the bath towel. Point the front where the barrel would go to the right.
3. Insert the trigger assembly into the trigger guard on the bottom shell. Attach the screws to the trigger assembly with the Phillips screwdriver.
4. Insert the hammer into the top-left side of the bottom shell. Attach the screws to the hammer with the Phillips screwdriver.
5. Put the top shell onto the bottom shell of the Tac-5. Attach the screw in front of the trigger guard with the Phillips screwdriver.
6. Attach the screws to the top-back edge of the Tac-5 near the hammer, at the top-middle edge and at the top-front edge with the Phillips screwdriver.
7. Push the gun barrel into the top of the Tac-5 from the front end. Continue pushing the gun barrel until it clicks into position.
8. Put the piston chamber on the bath towel with the open side facing up. Put one end of the spring over the hub inside of the left side of the piston chamber. Put the other end of the spring over the hub inside of the right side of the piston chamber.
9. Put the piston chamber into the open compartment at the top of the Tac-5.
10. Cock the hammer back with your fingers. Slide the sliding plate onto the top of the Tac-5 from the front.
11. Attach the screw in front of the hammer with the Phillips screwdriver. Release the hammer with your fingers.
12. Slide the gun scope over the front of the barrel and onto the top of the Tac-5. Stop sliding the gun scope when the end that is nearest the hammer reaches the gap that is in front of the screw that is in front of the hammer.
13. Tighten the screws on both sides of the gun scope with the Phillips screwdriver.
14. Insert the paintball magazine cartridge into the Tac-5's magazine compartment.
Tags: Phillips screwdriver, with Phillips, with Phillips screwdriver, bottom shell, piston chamber, Attach screws
